This decisive modification of packing geometry substantially improves lifetime and sealability of a state of the art pump and valve packing.

• The braided trapezoid cross section forms into a perfect square shape during installation
• Even pressure in all directions inside the stuffing box
• No OD leakage due to significantly improved k - factor
• No excessive compression along the shaft therefore reduced friction and heat generation
• Reduced wear of shaft and packing
• Packing rings do not rotate with the shaft
• Reduced run-in procedure and minimized readjustment required.
• Optimized efficiency and longer lifetime

Used to seal slow to fast rotating shafts. They contain a run in lubricant, which  acts at start up as lubrication film and supports the pliability of the braid. Also  suitable for mixers, agitators, autoclaves, refiners, kneaders and similar  applications.

Approvals: DVGW, KTW

Delivery format: Sheets: Special die cut rings and forms following DIN, custom shapes or alternate materials on request

Main Applications: Tube and pipe flanges, vessels, containers, boilers, cylinders, joints, casings, lids

Characteristics:

• A perfect selection of gasket material is based on operating conditions like pressure, temperature, media, surface pressure,
• Nonstick coating assures quick and scaling free dissassembling
• Do not use any surface treatment

Characteristics:

• Economical storage independent from shaft diameter, follow the packing diameter by 1.2 m-pieces n Replacement for machined lantern rings
• Universal use, excellent chemical and thermal resistance
• Easy to remove with packing extractor n No corrosion and wear of shafts, no canting during use

Measurements:

• The hight of the lantern ring depends on the size of packing (see chart).

Application limits: Temp. -100 ... + 250°C. pH 0 - 14 Form of delivery: 1,2 m per roll, special length